Interface Board Cases

Below you can find .STL files if you wish to 3D print your own case for our CAN 2.0B to USB Interface Board. These files are provided as-is, with no warranties or guarantees of any kind.

If you’d prefer a production-quality case, we also sell them.

Half-Case

This is a simple base that keeps the top of the circuit board exposed for easy access and visibility, while protecting the bottom from conductive surfaces and other conditions, and helping it lay flat.

Circuit board mounts to this base with 4 screws. Use care to avoid over-tightening!

Screw Size: Pan-head screws w/ flat-seat, typically #6 x 1/4″ for most prints

Interface Case – Half.stl

Full Case – Jumper Cut-Out

This option mostly encloses the circuit board, but leaves a cut-out for access to jumper pins and visibility to the terminal labels.

Case halves attach with 4 screws, sandwiching the circuit board in the middle. Use care to avoid over-tightening!

Screw Size: Flat-head screws w/ tapered-seat, typically #6 x 1/2″ for most prints

Interface Case – Bottom.stl

Interface Case – Top Cut.stl

Full Case – Enclosed

This option further encloses the circuit board, leaving only a cut-out for the terminal block and a view hole for the Status LED. Jumpers and terminal labels are not accessible with this case installed. We recommend you label the terminals on the outside of the case to prevent wiring mistakes and potential damage.

Case halves attach with 4 screws, sandwiching the circuit board in the middle. Use care to avoid over-tightening!

Screw Size: Flat-head screws w/ tapered-seat, typically #6 x 1/2″ for most prints

Interface Case – Bottom.stl

Interface Case – Top.stl